HP 2820

Changing the detect-dial-tone setting
Normally, the device begins dialing a fax number immediately. If you are using the device on
the same line as your telephone, turn on the detect-dial-tone setting. This prevents the
device from sending a fax while someone is on the telephone.
The factory-set default for detect dial tone is On for France and Hungary, and Off for all
other regions/countries.
To change the detect-dial-tone setting
1. On the device control panel, press M ENU .
2. Use the < or the > button to select Fax setup, and then press E
NTER .
3. Press > once to select Fax Send setup, and then press E
NTER .
4. Use the < or the > button to select Detect dial tone, and then press E
NTER .
5. Use the < or the > button to select On or Off, and then press E
NTER .
ENWW Changing the detect-dial-tone setting 105