HP 2820

Changing the silence-detect mode
This setting controls whether or not you can receive faxes from older-model fax machines
that do not emit a fax signal during fax transmissions. At the time of this publication, these
silent-model fax machines represented very few of the fax machines in use. The default
setting is Off. The silence-detect mode setting should be changed only if you regularly
receive faxes from someone who uses an older-model fax machine.
To change the silence-detect mode
1. On the device control panel, press M ENU .
2. Use the < or the > button to select Fax setup, and then press E
NTER .
3. Use the < or the > button to select Fax Recv. setup, and then press E
NTER .
4. Use the < or the > button to select Silence Detect, and then press E
NTER .
5. Use the < or the > button to select On or Off, and then press E
NTER to save your
selection.
112 Chapter 8 Fax ENWW