HP 2820

Setting the fax-error-correction mode
Usually, the device monitors the signals on the telephone line while it is sending or receiving
a fax. If the device detects an error during the transmission and the error-correction setting is
On, the device can request that the portion of the fax be resent. The factory-set default for
error correction is On.
You should turn off error correction only if you are having trouble sending or receiving a fax,
and you are willing to accept the errors in the transmission. Turning off the setting might be
useful when you are trying to send a fax overseas, or receive one from overseas, or if you
are using a satellite telephone connection.
To change the error-correction setting
1. On the device control panel, press M ENU .
2. Use the < or the > button to select Fax setup, and then press E
NTER .
3. Use the < or the > button to select All faxes, and then press E
NTER .
4. Use the < or the > button to select Error correction, and then press E
NTER .
5. Use the < or the > button to select On or Off, and then press E
NTER to save your
selection.
114 Chapter 8 Fax ENWW