Changing the number of copies
You can choose to have the default number of copies be any number from 1 to 99.
To change the number of copies for the current job
1. Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you
want to make for your current job.
2. Press S
TART
B
LACK
or S
TART
C
OLOR
to begin copying your job.
Note
The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control-panel display.
To change the default number of copies
1. On the device control panel, press M
ENU
.
2. Use the < or the > button to select Copy setup, and then press E
NTER
.
3. Use the < or the > button to select Def. # of copies, and then press E
NTER
.
4. Use the alphanumeric buttons to type the number of copies (between 1 and 99) that you
want as the default.
5. Press E
NTER
to save your selection.
Note
The factory-set default for the number of copies is 1.
70 Chapter 7 Copy ENWW
To Next Page
Loading...