C15 PDU Jumper Cord (ROW)
HP 2920-48G-POE+ Switch
J9729A#0D1
48 RJ-45 autosensing 10/100/1000 PoE+ ports
4 dual-personality ports
min=0 \ max=4 SFP Transceivers
1 - HP X332 575W 100-240VAC to 54VDC PS included
1U - Height
See
Configuration
Note:1, 3, 4, 5
PDU CABLE NA/MEX/TW/JP
J9729A#B2B
C15 PDU Jumper Cord (NA/MEX/TW/JP)
PDU CABLE ROW
J9729A#B2C
C15 PDU Jumper Cord (ROW)
HP 2920-48G-POE+ 740W Switch
J9836A
44 RJ-45 autosensing 10/100/1000 PoE+ ports
4 RJ-45 dual-personality 10/100/1000 PoE+ ports
min=0 \ max=4 SFP Transceivers
1 - HP X332 1050W 110-240VAC to 54VDC PS included
1U - Height
See
Configuration
Note:1, 3, 4, 5
PDU CABLE NA/MEX/TW/JP
J9836A#B2B
C15 PDU Jumper Cord (NA/MEX/TW/JP)
PDU CABLE ROW
J9836A#B2C
C15 PDU Jumper Cord (ROW)
Configuration Rules
Note 1
The following Transceivers install into this Module (Use #0D1 quoted to switch if switch is
CTO) - if applicable:
HP X121 1G SFP LC LH Transceiver
J4860C
HP X121 1G SFP LC LX Transceiver
J4859C
HP X121 1G SFP LC SX Transceiver
J4858C
HP X122 1G SFP LC BX-D Transceiver
J9142B
HP X122 1G SFP LC BX-U Transceiver
J9143B
HP X121 1G SFP RJ45 T Transceiver
J8177C
HP X111 100M SFP LC FX Transceiver
J9054C
HP X112 100M SFP LC BX-D Transceiver
J9099B
HP X112 100M SFP LC BX-U Transceiver
J9100B
Note 3
If this switch is factory installed in HP Racks, then the J9583A#0D1 is required.
CLIC Only - Allow the J9583AZ in all regions
Note 4
Localization required on orders without #B2B or #B2C options
QuickSpecs
HP 2920 Switch Series
Configuration
DA - 14499 Worldwide — Version 10 — December 9, 2013
Page 12
To Next Page
Loading...
