Need help?Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?
General| Model | HP ProCurve 2910al Switch |
|---|---|
| Layer | Layer 3 |
| Jumbo Frame Support | Yes |
| Power Device | Internal power supply |
| VLAN Support | Yes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Ports | 24 or 48 x 10/100/1000 ports |
| Uplink Ports | 4 x SFP (mini-GBIC) |
| Stacking | Yes |
| MAC Address Table Size | 32000 entries |
| Routing Protocol | RIP, OSPF, BGP, IGMP |
| Remote Management Protocol | SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP |
| Features | VLAN, QoS, IPv6, ACLs |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af |
| Operating Temperature | 0 to 45°C |
| Operating Humidity | 15% to 95% (noncondensing) |
| Power over Ethernet (PoE) | PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models |
Explains manual conventions, protocol acronyms, and document scope.
Details CLI command syntax, prompts, and screen output examples.
How to find help and download additional documentation and resources.
Guides for rapid setup, IP addressing, and physical installation.
Introduces IGMP, its general operation, features, terms, and usage limits.
Details how to manage IGMP through the Command Line Interface.
Explains IGMP mechanisms, fast-leave, proxy, querier roles, and address filtering.
Introduces IP routing and how IP addresses are assigned to interfaces.
Details IP routing tables, caches, protocols, and global/interface parameters.
Steps for configuring IP addresses, ARP, and proxy ARP.
How to configure ICMP, static routes, default routes, RIP, and IRDP.
Configuration of DHCP relay, Option 82, and UDP broadcast forwarding.
To Next Page