To Next Page

To Previous Page

IP Routing Features

Configuring RIP

Note IP routing must be enabled prior to enabling RIP. The first command in the

preceding sequence enables IP routing.

Enabling IP RIP on a VLAN

To enable RIP on all IP addresses in a VLAN, use ip rip in the VLAN context.

when the command is entered without specifying any IP address, it is enabled

in all configured IP addresses of the VLAN.

To enable RIP on a specific IP address in a VLAN, use ip rip [< ip-addr >| all ] in

the VLAN context and enter a specific IP address. If you want RIP enabled on

all IP addresses, you can specify all in the command instead of a specific IP

address.

Changing the RIP Type on a VLAN Interface

When you enable RIP on a VLAN interface, RIPv2-only is enabled by default.

You can change the RIP type to one of the following on an individual VLAN

interface basis:

■ Version 1 only

■ Version 2 only (the default)

■ Version 1 - or - version 2

To change the RIP type supported on a VLAN interface, enter commands such

as the following:

ProCurve(config)# vlan 1

ProCurve(vlan-1)# ip rip v1-only

ProCurve(vlan-1)# exit

ProCurve(config)# write memory

Syntax: [no] ip rip < v1-only | v1-or-v2 | v2-only >

Changing the Cost of Routes Learned on a VLAN Interface

By default, the switch interface increases the cost of a RIP route that is learned

on the interface. The switch increases the cost by adding one to the route's

metric before storing the route.

You can change the amount that an individual VLAN interface adds to the

metric of RIP routes learned on the interface.

3-30

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models