HP ProCurve 2910al Switch User Manual

IP Routing Features
Configuring DHCP Relay
VLAN
10
DHCP
Option
82
Server
Client
DROP
VLAN
20
VLAN
20
VLAN
30
VLAN
10
VLAN
20
APPEND
APPEND
Relay Agent “A”
Relay Agent “B”
Relay Agent “C”
Figure 3-23. Example Configured To Allow Multiple Relay Agents To Contribute an Option 82 Field
This is an enhancement of the previous example. In this case, each hop for an
accepted client request adds a new Option 82 field to the request. A DHCP
server capable of using multiple Option 82 fields can be configured to use this
approach to keep a more detailed control over leased IP addresses. In this
example, the primary DHCP policy boundary is at relay agent “A”, but more
global policy boundaries can exist at relay agents “B” and “C”.
Figure 3-24. Example Allowing Only an Upstream Relay Agent To Contribute an Option 82 Field
VLAN
10
DHCP
Option
82
Server
Client
DROP
VLAN
20
VLAN
20
VLAN
30
VLAN
10
VLAN
20
No Option 82
REPLACE
Relay Agent “A”
Relay Agent “B”
Relay Agent “C”
Like the first example, above, this configuration drops client requests with
spurious Option 82 fields from clients on the edge relay agent. However, in
this case, only the Option 82 field from the last relay agent is retained for use
by the DHCP server. In this case the DHCP policy boundary is at relay agent
“C”. In the previous two examples the boundary was with relay “A”.
Validation of Server Response Packets
A valid Option 82 server response to a client request packet includes a copy
of the Option 82 field(s) the server received with the request. With validation
disabled, most variations of Option 82 information are allowed, and the
corresponding server response packets are forwarded.
Server response validation is an option you can specify when configuring
Option 82 DHCP for append, replace, or drop operation. (Refer to “Forwarding
Policies” on page 3-54.) Enabling validation on the routing switch can enhance
protection against DHCP server responses that are either from untrusted
sources or are carrying invalid Option 82 information.
3-56

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models