IP Routing Features
Configuring IRDP
■ Maximum message interval and minimum message interval - when
IRDP is enabled, the routing switch sends the Router Advertisement
messages every 450-600 seconds by default. The time within this interval
that the routing switch selects is random for each message and is not
affected by traffic loads or other network factors. The random interval
minimizes the probability that a host will receive Router Advertisement
messages from other routers at the same time. The interval on each IRDP-
enabled routing switch interface is independent of the interval on other
IRDP-enabled interfaces. The default maximum message interval is 600
seconds. The default minimum message interval is 450 seconds.
■ Preference - If a host receives multiple Router Advertisement messages
from different routers, the host selects the router that send the message
with the highest preference as the default gateway. The preference can be
a number from -4294967296 to 4294967295. The default is 0.
Enabling IRDP Globally
To enable IRDP globally, enter the following command:
ProCurve(config)# ip irdp
This command enables IRDP on the IP interfaces on all ports. Each port uses
the default values for the IRDP parameters.
Enabling IRDP on an Individual VLAN Interface
To enable IRDP on an individual VLAN interface and configure IRDP param-
eters, enter commands such as the following:
ProCurve(config)# vlan 1
ProCurve(vlan-1)# ip irdp maxadvertinterval 400
This example shows how to enable IRDP on a specific interface (VLAN 1) and
change the maximum advertisement interval for Router Advertisement
messages to 400 seconds.
Syntax: [no] ip irdp [broadcast | multicast] [holdtime <seconds>] [maxadvertinterval
< seconds >] [minadvertinterval < seconds >] [preference < number >]
■ broadcast | multicast - This parameter specifies the packet type the routing
switch uses to send the Router Advertisement.
• broadcast - The routing switch sends Router Advertisements as IP
broadcasts.
3-41
To Next Page
Loading...
Need help?
General
