To Next Page

To Previous Page

IP Routing Features

Configuring RIP

Example: To configure the switch to filter out redistribution of static or

connected routes on network 10.0.0.0, enter the following commands:

ProCurve(config)# router rip

ProCurve(rip)# restrict 10.0.0.0 255.0.0.0

ProCurve(rip)# write memory

Note The default configuration permits redistribution for all default connected

routes only.

Syntax: restrict < ip-addr > < ip-mask > | < ip-addr /< prefix length >

This command prevents any routes with a destination address that is included

in the range specified by the address/mask pair from being redistributed by

RIP.

Modify Default Metric for Redistribution

The default metric is a global parameter that specifies the cost applied to all

RIP routes by default. The default value is 1. You can assign a cost from 1 – 15.

Example: To assign a default metric of 4 to all routes imported into RIP, enter

the following commands:

ProCurve(config)# router rip

ProCurve(rip)# default-metric 4

Syntax: default-metric < value >

The < value > can be from 1 – 15. The default is 1.

Enable RIP Route Redistribution

Note Do not enable redistribution until you have configured the redistribution

filters. Otherwise, the network might get overloaded with routes that you did

not intend to redistribute.

To enable redistribution of connected and static IP routes into RIP, enter the

following commands.

ProCurve(config)# router rip

ProCurve(rip)# redistribute connected

3-32

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models