HP ProCurve 2910al Switch User Manual

-------- --------- -------- ---------
IP Routing Features
Configuring DHCP Relay
Displaying the Hop Count Setting
To verify the current setting for increasing the hop count in DHCP requests,
enter the show dhcp-relay command. Note that the current setting is displayed
next to DHCP Request Hop Count Increment.
ProCurve# show dhcp-relay
Status and Counters - DHCP Relay Agent
DHCP Relay Agent Enabled : Yes
DHCP Request Hop Count Increment: Disabled
Option 82 Handle Policy : Replace
Remote ID : MAC Address
Client Requests Server Responses
Valid Dropped Valid Dropped
1425 2 1425 0
Figure 3-18. Example of show dhcp-relay Command Showing Hop Count
Increment
3-47

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models