HP ProCurve 2910al Switch User Manual

IP Routing Features
Overview of IP Routing
IP Interface Parameters for Routing Switches
Table 3-2 lists the interface-level IP parameters for routing switches.
Table 3-2. IP Interface Parameters – Routing Switches
Parameter Description Default See page
IP address A Layer 3 network interface address; separate IP
addresses on individual VLAN interfaces.
None configured *
Metric A numeric cost the router adds to RIP routes learned
on the interface. This parameter applies only to RIP
routes.
1 (one) 3-29
ICMP Router
Discovery
Protocol (IRDP)
Locally overrides the global IRDP settings. See table 3-
1 on page 3-8 for global IRDP information.
Disabled 3-41
IP helper address The IP address of a UDP application server (such as a
BootP or DHCP server) or a directed broadcast
address. IP helper addresses allow the routing switch
to forward requests for certain UDP applications from
a client on one subnet to a server on another subnet.
None configured 3-45
*
Refer to the chapter titled “Configuring IP Addressing” in the Management and Configuration Guide for your switch.
3-12

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models