HP ProCurve 2910al Switch User Manual

IP Routing Features
Configuring RIP
Parameter Description Default
metric A numeric cost the routing switch adds to RIP routes
learned on the interface. This parameter applies only
to RIP routes.
1
IP address The routes that a routing switch learns or advertises
can be controlled.
The routing switch
learns and
advertises all RIP
routes on all RIP
interfaces
loop
prevention
The method the routing switch uses to prevent routing
loops caused by advertising a route on the same
interface as the one on which the routing switch
learned the route.
Poison reverse
• Split horizon - the routing switch does not
advertise a route on the same interface as the one
on which the routing switch learned the route.
• Poison reverse - the routing switch assigns a cost
of 16 (“infinite” or “unreachable”) to a route before
advertising it on the same interface as the one on
which the routing switch learned the route.
receive Define the RIP version for incoming packets V2-only
send Define the RIP version for outgoing packets V2-only
Configuring RIP Parameters
Use the following procedures to configure RIP parameters on a system-wide
and individual VLAN interface basis.
Enabling RIP
RIP is disabled by default. To enable it, use one of the following methods.
When you enable RIP, the default RIP version is RIPv2-only. You can change
the RIP version on an individual interface basis to RIPv1 or
RIPv1-or-v2 if needed.
To enable RIP on a routing switch, enter the following commands:
ProCurve(config)# ip routing
ProCurve(config)# router rip
ProCurve(rip)# exit
ProCurve(config)# write memory
Syntax: [no] router rip
3-29

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models