To Next Page

To Previous Page

IP Routing Features

Configuring RIP

Not e ICMP Host Unreachable Message for Undeliverable ARPs. If the

routing switch receives an ARP request packet that it is unable to deliver to

the final destination because of the ARP timeout and no ARP response is

received (the routing switch knows of no route to the destination address),

the routing switch sends an ICMP Host Unreachable message to the source.

RIP Parameters and Defaults

The following tables list the RIP parameters, their default values, and where

to find configuration information.

RIP Global Parameters

3-3 lists the global RIP parameters and their default values.

Table 3-3. RIP Global Parameters

Parameter Description Default

RIP state Routing Information Protocol V2-only. Disabled

auto-summary Enable/Disable advertisement of summarized routes. Enabled

metric Default metric for imported routes. 1

redistribution RIP can redistribute static and connected routes. (RIP

redistributes connected routes by default, when RIP is

enabled.)

Disabled

RIP Interface Parameters

3-4 lists the VLAN interface RIP parameters and their default values.

Table 3-4. RIP Interface Parameters

Parameter Description Default

RIP version The version of the protocol that is supported on the

V2-only

interface.

The version can be one of the following:

• Version 1 only

• Version 2 only

• Version 1 or version 2

3-28

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models