To Next Page

To Previous Page

Getting Started

Conventions

■ Boldface indicates use of a CLI command, part of a CLI command syntax,

or other displayed element in general text. For example:

“Use the copy tftp command to download the key from a TFTP server.”

■ Italics indicate variables for which you must supply a value when execut-

ing the command. For example, in this command syntax, you must provide

one or more port numbers:

Syntax: aaa port-access authenticator < port-list >

Command Prompts

In the default configuration, your switch displays a CLI prompt similar to the

following example:

ProCurve 2910al#

To simplify recognition, this guide uses ProCurve to represent command

prompts for all switch models. For example:

ProCurve#

(You can use the hostname command to change the text in the CLI prompt.)

Screen Simulations

Displayed Text. Figures containing simulated screen text and command

output look like this:

ProCurve> show version

Image stamp:

Boot Image:

/sw/code/build/info

November 6, 2008 13:43:13

W.14.01

139

Primary

ProCurve>

Figure 1-1. Example of a Figure Showing a Simulated Screen

In some cases, brief command-output sequences appear without figure iden-

tification. For example:

ProCurve(config)# clear public-key

ProCurve(config)# show ip client-public-key

show_client_public_key: cannot stat keyfile

1-3

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models