HP 3-in-1 NAS - Page 24

2–6 Maintenance and Service Guide
Troubleshooting
A new device is not
recognized as part of
the system.
(Continued)
The device was
connected while
the system was on.
Turn off the computer,
turn on the device (if
applicable), and then
turn on the computer.
Cabling is incorrect. Be sure that the device
cable is in the correct
connector on the
docking station.
You may need to install
device drivers on the
computer.
Install drivers according
to the device
manufacturer’s
instructions.
Table 2-3
External Device Problems and Solutions
(Continued)
Problem Possible Cause Solution