HP 3300A User Manual

TM 11-6625-2495-14&P
TABLE OF CONTENTS (Continued)
Section Page
I GENERAL INFORMATION........................1-1
1-1. General..........................................1-1
1-5. Electronic Frequency Control........1-1
1-7. Output System...............................1-1
1-9. Instrument and Manual
Identification............................1-1
Section Page
II INSTALLATION..........................................2-1
2-1. Introduction....................................2-1
2-3. Initial Inspection.............................2-1
2-5. Power Requirements.....................2-1
2-7. Grounding Requirements ..............2-1
2-10. Installation .....................................2-1
2-12. Bench Mounting ............................2-1
2-14. Rack Mounting ..............................2-1
2-16. Repackaging for Shipment............2-1
Section Page
III OPERATING INSTRUCTIONS ..................3-1
3-1. Introduction....................................3-1
3-3. Controls and Indicators .................3-1
3-5. Turn On Procedure........................3-1
3-7. Operating Instructions ...................3-1
Section Page
IV THEORY OF OPERATION ........................4-1
4-1. Introduction....................................4-1
4-3. General Description.......................4-1
4-13. Schematic Theory .........................4-2
4-14. Frequency Control Network...........4-2
4-17. Current Sources ............................4-2
4-19. Triangle Integrator.........................4-2
4-21. Voltage Comparator
Multivibrator ............................4-2
4-23. Sine Wave Synthesizer. ................4-2
4-25. Output Amplifiers...........................4-2
4-27. Power Supply ................................4-3
4-30. Oven..............................................4-3
Section Page
V MAINTENANCE .........................................5-1
5-1. Introduction....................................5-1
5-3. Performance Checks.....................5-1
5-5. Dial Accuracy.................................5-1
5-7. Distortion Check............................5-1
5-8. Frequency Response ....................5-1
5-10. Maximum Output Level,
No Load ..................................5-1
Section Page
V MAINTENANCE (Cont’d)
5-13. Maximum Output Level,
Loaded.................................... 5-1
5-16. Square Wave Response............... 5-2
5-18. Sync Output .................................. 5-2
5-19. Remote Frequency Control
Check ..................................... 5-2
5-20. Channel B-A Check ...................... 5-3
5-21. Adjustment and Calibration........... 5-3
5-22. Cover Removal ............................. 5-3
5-23. Power Supply Adjustments........... 5-3
5-26. Power Supply Ripple Check.......... 5-3
5-27. Power Supply Regulation Check... 5-3
5-28. Oven Regulation. .......................... 5-3
5-29. Frequency Symmetry Adjust......... 5-3
5-32. Current Source Adjust................... 5-5
5-33. Dial Adjustment............................. 5-5
5-34. Dial Calibrate................................. 5-5
5-38. Distortion Adjust............................ 5-6
5-39. DC Output Level Adjust ................ 5-6
5-41. Square Wave Adjust ..................... 5-6
5-43. Repair Procedures........................ 5-6
5-44. Servicing Etched Circuit Boards ... 5-6
5-46. Servicing Rotary Switches ............ 5-7
5-48. Replacement of Factory
Selected Components............ 5-7
5-50. Troubleshooting Procedure........... 5-7
5-54. Malfunction Isolation Plug............. 5-7
5-56. Precautions................................... 5-8
5-59. Troubleshooting Tree.................... 5-8
5-62. Troubleshooting Tables ................ 5-10
Section Page
VI CIRCUIT DIAGRAMS ................................ 6-1
6-1. Introduction ................................... 6-1
6-3. Schematic Diagrams..................... 6-1
6-4. Component Location Diagrams .... 6-1
6-5. Plug-In Receptacle........................ 6-1
Section Page
VII REPLACEABLE PARTS............................ 7-1
7-1. Introduction ................................... 7-1
7-4. Ordering Information..................... 7-1
7-6. Non-Listed Parts ........................... 7-1
Appendix
A References................................................. A-1
B Not Applicable.
C Not Applicable.
D Maintenance Allocation.............................. D-1
LIST OF TABLES
Number Page
1-1. Specifications .............................................1-0
5-1. Required Test Equipment...........................5-0
5-2. Power Supply Adjustments.........................5-3
5-3. Integrator Feedback Capacitance. .............5-7
Number Page
5-4. Troubleshooting Aid................................... 5-8
5-5. Maintenance Correlation Table.................. 5-10
5-6. Factory Selected Components................... 5-11
7-1. Replaceable Parts...................................... 7-2
7-2. Part No - National Stock
No. Cross Reference Index.................. 7-9
ii

HP 3300A Specifications

General

Brand	HP
Model	3300A
Category	Inverter
Language	English