ENWW Replacing supply items 95
6 Guide the left side of the transfer unit into the front door of the printer. Insert the two pegs on
the left side into the holes, and then lower the right side into the door.
7 Make sure that the blue button on the right blue handle has released (popped up). If the button
has not released, grasp the right blue handle and pull the transfer unit toward you.
8 Firmly close the front door.
9 After the front door is closed, after a short time, the printer control panel displays the message
NEW TRANSFER KIT.
10 If the message NEW TRANSFER KIT appears, go to step 12. If the message does not appear,
you must reset the transfer unit count. To reset the transfer unit count, do the following.
To Next Page
Loading...
