HP 3500 Series - Page 325

ENWW Printer error troubleshooting 311
FLASH FILE
OPERATION FAILED
alternates with
Ready
To clear press
HP 3700 only.
The printer received a PJL file system
command that attempted to perform an
illogical operation (for example, to
download a file to a non-existent
directory).
1. Printing may continue.
2. To remove this message from the display,
press .
3. If the message reappears, there might be
a problem with the software application.
FLASH FILE
SYSTEM IS FULL
alternates with
Ready
To clear press
HP 3700 only.
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system
is full.
1. Use HP Web Jetadmin software to delete
files from the Flash Memory and try again.
2. To remove this message from the display,
press .
SeeHP Web Jetadmin in chapter 3.
FLASH IS
WRITE PROTECTED
alternates with
Ready
To clear press
HP 3700 only.
The file system is protected and no
new files can be written to it.
1. To enable writing to the Flash Memory,
turn off write protection using HP Web
Jetadmin.
2. To remove this message from the display,
turn the printer off and then back on. See
HP Web Jetadmin in chapter 3.
[FS ] DEVICE
FAILURE
alternates with
To clear press
HP 3700 only.
Device failure
[FS ] DEVICE can be either:
[FS FLASH] DEVICE or
[FS RAM DISK] DEVICE
1. To remove this message from the display,
press .
[FS ] FILE
OPERATION FAILED
alternates with
To clear press
HP 3700 only.
This message indicates a PJL file
system command was received that
attempted to perform an illogical
operation (that is, download a file to a
non-existent directory).
[FS ] DEVICE can be either:
[FS FLASH] DEVICE or
[FS RAM DISK] DEVICE
1. To remove this message from the display,
press .
[FS ] FILE SYSEM
IS FULL
alternates with
To clear press
HP 3700 only.
This message indicates a PJL file
system command was received that
attempted to store something on a file
system but was unsuccessful due to
the file system being full.
[FS ] DEVICE can be either:
[FS FLASH] DEVICE or
[FS RAM DISK] DEVICE
1. To remove this message from the display,
press .
Table 7-2 Alphabetical printer messages (continued)
Message Description Action