EasyManua.ls Logo

HP 3500 Series - Page 334

HP 3500 Series
554 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
320 Troubleshooting ENWW
REPLACE <COLOR>
CARTRIDGE
alternates with
For help press
The identified print cartridge has
reached the end of life. Printing will not
continue until the cartridge is replaced.
Press for help.
or
See Transfer unit removal (in chapter 6) and
Ordering parts (in chapter 8) for more
information.
Or, if the cartridge is new:
1. Replace the memory controller PCB
2. Replace the DC controller PCB.
REPLACE <COLOR>
CARTRIDGE
alternates with
To continue press .
The identified print cartridge is nearing
the end of its useful life and the
SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP. To override,
press . Or, if the cartridge is new, the
new cartridge is defective, the memory
controller PCB or the DC controller
PCB is defective
1. Order the identified print cartridge.
2. Press to continue.
or
Press for help.
See Ordering parts (in chapter 8) for more
information.
REPLACE FUSER KIT
For help press
The fuser kit is at end of life. Press for help.
or
See Fuser removal (in chapter 6) and
Ordering parts (in chapter 8) for more
information.
REPLACE FUSER KIT
alternates with
To continue press
The fuser is near end of life and the
SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP.
1. Order the fuser kit.
2. Press to continue printing. Printing can
continue until REPLACE FUSER KIT is
reached.
or
Press for help.
See Ordering parts (in chapter 8) for more
information.
REPLACE SUPPLIES
alternates with
For status press
At least one supply item is out and
needs to be replaced and another
supply item is either out or low.
1. Press to identify which supplies should
be replaced.
2. Press for help.
or
Refer to the appropriate section in chapter 6
(Removal and replacement) or Ordering
parts (in chapter 8) for more information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and
the SUPPLIES LOW setting in
SYSTEM SETUP is set to STOP.
1. Press to identify which supplies should
be ordered.
2. Order the identified supplies.
3. Press to continue printing.
See Ordering parts (in chapter 8) for more
information.
Table 7-2 Alphabetical printer messages (continued)
Message Description Action

Other manuals for HP 3500 Series

Related product manuals