160 Removing and replacing parts EN
Tray 1 pickup roller
Figure 64. Removing the pickup roller (shown with envelope entrance cover removed)
1 Open tray 1. The tray 1 pickup roller is in the center of the tray 1 pickup assembly.
2 Grasp the envelope entrance cover directly above the pickup roller and pull it straight away from
the printer.
3 Use a flat-blade screwdriver to pry open the blue latch on the roller.
4 Lift the roller out.
Hint To replace the roller, make sure the pin in the roller lines up with the hole in the shaft. Then, ensure
the blue latch snaps securely in place.
Figure 65. Installation of tray 1 pickup roller
To Next Page
Loading...