EN Chapter 6 Removing and replacing parts 161
Tray 1 pickup assembly
1 To remove the tray 1 pickup assembly:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the left side cover (page 143).
e Remove the front right side cover (page 144).
f Remove tray 1 (page 146).
Figure 66. Removing the gear cover
2 Remove the gear cover as follows:
a. Remove the self-tapping screw (callout 1) at the bottom of the gear cover.
b. Remove the long screw (116 mm/4.8 inches) on the right side of the tray 1 pickup assembly
(callout 2).
c. Remove the gear cover by pressing down on the claw.
2
2
2
1
To Next Page
Loading...