162 Removing and replacing parts EN
Figure 67. Removing the tray 1 pickup assembly—right side
3 Disconnect the three-pin solenoid connector (callout 1) on the right side of the tray 1 pickup
assembly and unroute the cable from the cable guide. (Note the way the cables are routed for
replacement.)
Note The solenoid connector is a three-part connector. Do not lose the gender-changer (center piece).
Figure 68. Removing the tray 1 pickup assembly—left side
4 Unplug the connector (callout 1) to the engine controller board on the left side of the tray 1 pickup
assembly. (Note the way the cables are routed for replacement.)
5 Remove the long screw (116 mm/4.8 inches) from the left side of the assembly.
2
1
2
1
To Next Page
Loading...