EN Chapter 6 Removing and replacing parts 165
Registration assembly
Figure 71. Removing the registration assembly
1 To remove the registration assembly:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the left side cover (page 143).
e Remove the front right side cover (page 144).
f Remove tray 1 (page 146).
g Remove the tray 1 pickup assembly (page 161).
h Lift aside the right side toner cartridge guide (page 164). It is not necessary to unplug the
connectors.
2 Remove the three self-tapping screws (callout 1) shown. (Lift the green handle on the right end of
the registration assembly to get to the screw on the left rear side.)
2
1
To Next Page
Loading...