EN Chapter 6 Removing and replacing parts 167
Paper feed assembly
1 To remove the paper feed assembly:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the left side cover (page 143).
e Remove the front right side cover (page 144).
f Remove tray 1 (page 146).
g Remove the tray 1 pickup assembly (page 161).
The paper feed assembly is on the front of the printer.
Figure 73. Unplugging the connector to the paper feed assembly
2 Unplug and unroute the two-pin connector (callout 1) from the right side.
CAUTION For replacement of the paper feed assembly, note the way the wires are routed to the connector. If a
wire is routed improperly, it can be damaged.
2
1
Note wire routing
To Next Page
Loading...