170 Removing and replacing parts EN
Delivery drive assembly
Figure 77. Removing the delivery drive assembly
1 To remove the delivery drive assembly:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the rear cover/rear output bin (page 145).
e Remove the fuser assembly (page 149).
f Remove the output delivery assembly (page 152)
g Remove the formatter assembly (page 151).
2 Remove the two screws (callout 1).
3 Unplug the three-pin connector (callout 2) shown.
4 Lift the delivery drive assembly upward, away from the printer.
2
1
2
2
To Next Page
Loading...