EN Chapter 6 Removing and replacing parts 171
Separating the engine module from the paper-feed module
1 To separate the engine module from the paper-feed module:
a Remove the tray 2 dust cover or the duplexer (if installed).
a Remove the rear right side cover (page 138).
b Remove the formatter assembly (page 151).
c Remove the two long screws from the tray 1 pickup assembly (page 161 and 162).
Figure 78. Unplugging the connector to the paper-feed module
2 Unplug the connector (callout 1) to the paper-feed module on the right rear side of the printer
(under the formatter assembly). Remove the cable from its brackets.
3 Remove the two screws (callout 2), or one screw, if the printer drive assembly has been
removed.
2
1
2
2
To Next Page
Loading...