HP 4100tn - LaserJet B/W Laser Printer - Page 198

196 Troubleshooting EN
DISK FILE SYSTEM IS
FULL
The disk file system is full. 1. Delete all unnecessary files
from the EIO disk and then try
again. Use HP Resource
Manager to download or delete
files and fonts. (See the software
help for more information.)
2. Advise the customer to
increase the permanent storage
(use a larger EIO disk or add a
RAM DIMM).
DISK IS WRITE
PROTECTED
The EIO disk is protected,
and no new files can be
written to it.
Disable the write protection
through HP Resource Manager.
DUPLEX ERROR
CHECK DUPLEXER
There is a problem with the
duplexer.
1. Make sure the duplexer is
properly installed.
2. Make sure the right-angle
power cord is used for the printer
and the duplexer is making a
good connection.
3. Replace the duplexer PCA.
EIO DISK [x] NOT
FUNCTIONAL
The EIO disk is not
working correctly.
1. Reseat the EIO disk in slot
[X]
.
2. Remove and replace the EIO
disk in slot
[X]
.
EIO [x] NOT
FUNCTIONAL
The EIO disk is not
working correctly.
1. Reseat the EIO disk in slot
[X]
.
2. Remove and replace the EIO
disk in slot
[X]
.
EIO [x]
INITIALIZING
alternates with
DO NOT POWER OFF
The disk accessory in EIO
slot [x] is initializing.
1. Wait for the message to
disappear (up to five minutes). If
the printer EIO card is operating
correctly and communicating with
the network, this message
disappears after approximately
one minute and no action is
required.
2. If the EIO card is unable to
communicate with the network,
this message remains for five
minutes and then disappears.
The problem might be an
unseated EIO card, a bad EIO
card, a bad cable or connection
on the network, or a network
problem.
3. Contact the network
administrator.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action