EN Chapter 7 Troubleshooting 197
ENV FEEDER LOAD
[TYPE] [SIZE]
A job has been sent to the
envelope feeder and the
feeder is empty, the wrong
size is loaded in the feeder,
or the type and size are set
incorrectly on the control
panel.
1. Load the requested envelope
type and size into the envelope
feeder.
2. Make sure the envelope size
and type are set correctly from
the paper-handling menu in the
printer control panel.
3. Press G
O
if the desired
envelope is already loaded in the
feeder.
4. Press -V
ALUE
+ to scroll through
other available types and sizes.
5. Press S
ELECT
to accept the
alternate type or size.
ENVELOPE FEEDER
SIZE = [xxxxx]
The printer is asking what
size envelopes have been
loaded in the envelope
feeder.
In response, you can take either
of the following actions:
1. Press S
ELECT
to accept the
current envelope size.
2. Press -V
ALUE
+ to change the
size and then press S
ELECT
to
accept the new size.
If you do not press any buttons,
the message disappears in about
one minute.
Note
Changing the size here changes
the default for the envelope-
feeder size in the paper-handling
menu.
ENVELOPE FEEDER
TYPE = [xxxxx]
The printer has received a
job under the following
conditions:
!
The envelope type the
job requested is not
available in the printer.
!
Envelopes have been
placed in the envelope
feeder (thus triggering
the paper sensor).
You can take either of the
following actions:
1. Press S
ELECT
to accept the
paper type and then press G
O
.
2. Press +V
ALUE
- to change the
type, press S
ELECT
to accept the
new type, and then press G
O
to
continue.
FLASH DEVICE
FAILURE
The flash DIMM had a
critical or fatal failure.
1. Reseat the flash DIMM and
ensure it is locked into place.
2. Remove the flash DIMM and
replace it with a new one.
FLASH FILE
OPERATION FAILED
The requested operation
could not be performed (for
example, attempting to
download a file to a
nonexistent directory).
1. Check the file name and the
directory name.
2. Reseat the flash DIMM.
3. Retry the operation.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
To Next Page
Loading...