HP 4100tn - LaserJet B/W Laser Printer - Page 200

198 Troubleshooting EN
FLASH FILE SYSTEM
IS FULL
The flash file system is full. Delete unnecessary files from the
flash DIMM and try again.
Use HP Resource Manager to
download or delete files and
fonts. (See the software help for
more information.)
FLASH IS WRITE
PROTECTED
The flash DIMM is
protected and no new files
can be written to it.
Disable the write protection
through HP Resource Manager.
INPUT DEVICE
CONDITION [XX.YY]
An input paper-handling
device has a condition that
needs attention before
printing can resume.
1st X = Device number in
chain
2nd X= Device type
(three types):
1 = Input
2 = Output
3 = Stapler/stacker unit
YY = Device specific error
1. Turn the printer off.
2. Disconnect the cable to the
input paper handling devices and
then reconnect it.
3. Ensure the device is properly
connected and any doors or
paper guides are properly closed.
4. Turn the printer on.
5. See the documentation that
came with the paper-handling
device for assistance.
INSTALL DUPLEXER
The printer is unable to
print the current job
because the duplexer is
not installed or not inserted
correctly.
1. Install or reinsert the duplexer
and ensure it is fully seated.
2. Ensure the right-angle power
cord is used for the printer.
INSTALL TONER
CARTRIDGE
The toner cartridge has
been removed and must
be reinstalled for printing to
continue.
Reinstall the toner cartridge and
ensure it is fully seated.
INSTALL TRAY [X]
The printer is unable to
print the current job
because the specified tray
[X]
is open or not inserted
correctly.
1. Reinsert the specified tray.
2. Check for damaged tabs on
the right side of the tray.
3. Check for damaged tray
sensor switches in the printer.
4. Replace the PCA controller in
the feeder.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action