HP 4100tn - LaserJet B/W Laser Printer - Page 205

EN Chapter 7 Troubleshooting 203
TRAY [X] EMPTY
[TYPE] [SIZE]
The specified tray is empty,
but the current job does
not need this tray in order
to print correctly.
If this message appears
and the tray contains print
media, a sensor could be
damaged.
PS105 detects paper in
tray 1.
PS101 detects paper in
tray 2.
PS1001 detects paper in
the optional 500-sheet
feeder.
See figure 113 on page
263 and figure 114 on
page 264 for sensor
locations.
1. Load the empty tray (
x
) to clear
the message.
If you do not load the specified
tray, the printer will continue
printing from the next available
tray, and the message remains.
2. If the message remains after
the specified tray is loaded, check
sensor arm flags for damage and
be sure they move freely.
4. Replace defective paper out
sensors.
TRAY [x] LOAD [TYPE]
[SIZE]
where x is tray 2, 3, or
4
This message occurs for
the following reasons:
!
Tray 2, 3, or 4 was
requested, but the tray
is empty.
!
Tray 2, 3, or 4 was
requested, but the
adjustments are not set
for the requested type
or size.
1. Make sure that all three paper
size adjustments have been
made (see the explanation of
adjustments in table 39 on page
220). Also make sure that the
type has been set at the control
panel.
2. Load the requested media into
an indicated tray. Ensure the tray
is fully seated.
3. If you are trying to print on A4-
or letter-size media and this
message appears, make sure the
default paper size is set correctly
from the printing menu in the
printer control panel and also in
the software program.
4. Press G
O
to print from the next
available tray.
5. Press -V
ALUE
+ to scroll through
the available types and sizes.
6. Press S
ELECT
to accept the
alternate type or size.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action