202 Troubleshooting EN
RAM DISK FILE
SYSTEM IS FULL
The RAM disk file system
is full.
1. Delete unnecessary files and
then try again, or turn the printer
off, and then turn the printer on to
delete all files on the device.
(Delete files using HP Resource
Manager or another software
utility. See the software online
help for more information.)
2. If the message persists,
increase the size of the RAM
disk. Change the RAM disk size
from the configuration menu on
the printer control panel. HP
Resource Manager can also be
used to increase or decrease the
RAM disk size.
RAM DISK IS WRITE
PROTECTED
The RAM disk is protected,
and no new files can be
written to it.
Disable the write protection
through HP JetAdmin.
TONER LOW
The message first appears
when about 15 percent of
the toner is remaining in
the toner cartridge (about
1,500 pages remaining for
the 10,000-page cartridge
and about 900 pages
remaining for the 6,000-
page cartridge at five
percent coverage).
Depending on how the
printer has been
configured in the
configuration menu, it will
either continue to print or
stop.
1. If the printer has stopped, you
can resume printing by pressing
G
O
for each job.
2. Advise the customer to have a
replacement toner cartridge on
hand.
TONER OUT
The toner cartridge has
run out of toner.
Depending on how the
printer has been
configured, it will either
continue to print or stop.
Due to the resolution of the
toner level sensor, it is
possible that a small
amount of toner (less than
one percent) might still be
present in the cartridge.
1. If the printer has stopped, you
can resume printing by pressing
G
O
for each job.
2. Replace the toner cartridge.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
To Next Page
Loading...