206 Troubleshooting EN
UNSUPPORTED SIZE IN
TRAY [yy]
An external paper-handling
device detected an
unsupported media size.
The printer will go offline
until the condition is
corrected.
Verify the media meets the
supported size specifications in
table 7 on page 26.
USE [TYPE]
[SIZE] INSTEAD?
If the requested media size
or type is not loaded, the
printer asks if it should use
another size or type
instead.
1. Press -V
ALUE
+ to scroll through
the available types and sizes.
2. Press S
ELECT
to accept the
alternate type or size.
WAIT FOR PRINTER TO
REINITIALIZE
The RAM disk setting has
been changed from the
printer control panel. This
change will not take effect
until the printer
reinitializes.
If you change the mode of the
external device, turn the printer
off, turn the printer on and wait for
the printer to reinitialize.
xx.yy PRINTER ERROR
PRESS GO TO
CONTINUE
A printer error has
occurred that can be
cleared by pressing G
O
on
the printer control panel.
Press G
O
on the printer control
panel.
13.XX PAPER JAM
[LOCATION]
Media is jammed at the
specified location (and
possibly at other
locations).
If the message persists
after all jams have been
cleared, a sensor or
sensor lever might be
stuck or broken.
For all jam messages, do the
following:
1. Remove jammed print media
from the specified location.
Check the entire paper path for
other pieces of media in the path.
2. Open and close the top cover
to clear the message.
3. If the jam reoccurs, see
“General paper-path
troubleshooting” on page 220.
4. Check sensors and flags in the
paper path for proper operation.
For sensor locations, see page
263.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
To Next Page
Loading...