Error Messages in Alphabetical Order
0
168
Block data not allowed
A legal block data element was encountered but was not allowed by the analyzer at this point
in parsing.
C
13
CALIBRATION ABORTED
The calibration in progress was terminated due to a change of the active channel or stimulus
parameters.
11
CALIBRATION REQUIRED
No valid calibration coecients were found when you attempted to turn calibration
on
.
126
CAN'T CHANGE NUMBER OF POINTS
The number of points of the spectrum analyzer mode cannot be to change manually, except in
zero span.
133
CAN'T CHANGE ON LIST SWEEP
When list sweep is selected, the following parameters are not allowed to be changed:
CENTER, SPAN, START, STOP
NOP
IFBW or RBW
POWER
DC SOURCE
Modify the list table to change these parameters in the list sweep
.
97
CAN'T CHANGE WHILE DATAMATH ON
The setting cannot be changed when the data math function is used.
99
CAN'T CHANGE WHILE DUAL CHAN OFF
The Cross channel cannot be turned on when dual channel is o. Turn on the dual channel
before the cross channel is turned on.
82
CAN'T CHANGE- ANOTHER CONTROLLER ON BUS
The analyzer cannot assume the mode of system controller until the active controller is
removed from the bus or relinquishes the bus. See
Programming Manual
.
134
CAN'T COUPLE IN CURRENT INPUTS
When one channel measures a ratio measurement, and the other one measures an absolute
measurement (for example: A/R and B),
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
COUPLED CH
can not be turned on.
114
CAN'T SAVE GRAPHICS WHEN COPY IN PROGRESS
If you attempt to save graphics when a print is in progress
, this error message is displayed.
Messages-2
To Next Page
Loading...
