HP 5120 SI Series

NOTE: Details are not available for all accessories. The following specifications were available at the time of publication.
HP X120 1G SFP LC SX
Transceiver (JD118B)
A small form-factor
pluggable (SFP) Gigabit
Ethernet LX transceiver
that provides a full duplex
Gigabit solution up to
550m on MMF or 10Km on
SMF.
Ports 1 LC 1000BASE-SX port (IEEE 802.3z Type 1000BASE-SX)
Connectivity Connector type LC
Wavelength 850 nm
Physical characteristics Dimensions 2.17(d) x 0.6(w) x 0.46(h) in. (5.51 x 1.52 x 1.17
cm)
Full configuration weight 0.04 lb. (0.02 kg)
Electrical characteristics Power consumption
typical
0.8 W
Power consumption
maximum
1.0 W
Cabling Maximum distance:
• FDDI Grade distance = 220m
• OM1 = 275m
• OM2 = 500m
• OM3 = Not Specified by standard
Cable length up to 550m
Fiber type Multi Mode
Services Refer to the HP website at www.hp.com/networking/services for details on
the service-level descriptions and product numbers. For details about services
and response times in your area, please contact your local HP sales office.
HP X120 1G SFP LC LX
Transceiver (JD119B)
A small form-factor
pluggable (SFP) Gigabit LX
transceiver that provides a
full duplex Gigabit solution
up to 550m on MMF or
10Km on SMF
Ports 1 SFP 1000BASE-LX port (IEEE 802.3z Type 1000BASE-LX)
Connectivity Connector type LC
Wavelength 1300 nm
Physical characteristics Dimensions 2.17(d) x 0.6(w) x 0.46(h) in. (5.51 x 1.52 x 1.17
cm)
Full configuration weight 0.04 lb. (0.02 kg)
Electrical characteristics Power consumption
typical
0.8 W
Power consumption
maximum
1.0 W
Cabling Cable type:
Either single mode or multimode;
Maximum distance:
• 550m for Multimode
• 10km for Singlemode
Fiber type Both
QuickSpecs
HP 5120 SI Switch Series
Accessory Product Details
DA - 13795 Worldwide — Version 12 — November 12, 2013 Page 18