Need help?Do you have a question about the HP 5120 SI Series and is the answer not in the manual?
General| Operating Temperature | 0°C to 45°C |
|---|---|
| Uplink Ports | 4 x SFP |
| MAC Address Table Size | 16384 entries |
| Routing Protocol | RIP, RIPng |
| Management | CLI, Web-based GUI, SNMP |
| Form Factor | 1U |
| Jumbo Frame Support | Yes |
| Operating Humidity | 10% to 90% (noncondensing) |
Creates a NAS ID profile and maintains bindings between NAS IDs and VLANs.
Specifies the command line accounting method using an HWTACACS scheme.
Configures the default authentication method for an ISP domain.
Limits the number of concurrent users for a local user account.
Configures binding attributes for a local user, such as IP, MAC, or VLAN.
Sets or removes the password for a local user account.
Creates and configures a RADIUS scheme for authentication and accounting.
Specifies the primary RADIUS accounting server and its UDP port.
Specifies the primary RADIUS authentication/authorization server and its UDP port.
Displays 802.1X information, including session, statistics, and configurations.
Specifies an EAP message handling method for 802.1X authentication.
Configures an 802.1X guest VLAN for specified or all ports.
Displays MAC authentication settings and statistics for ports.
Specifies a global or port-specific authentication domain for MAC users.
Sets the maximum number of concurrent MAC authentication users on a port.
Creates and configures an IPsec policy, specifying generation mode and sequence number.
Creates an IPsec proposal and enters its view for defining security parameters.
Displays brief or detailed information about all IPsec Security Associations (SAs).
Creates an IKE peer and enters its view for configuring negotiation parameters.
Creates an IKE proposal and enters its view for defining security parameters.
Displays information about the current IKE Security Associations (SAs).
To Next Page
