HP 5120 SI Series User Manual

198
HABP configuration commands
display habp
Syntax
display habp [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display habp command to display HABP configuration information.
If the HABP function is not enabled on the device, this command does not display the HABP configuration
but only the running status of the HABP function.
Examples
# Display HABP configuration information.
<Sysname> display habp
Global HABP information:
HABP Mode: Server
Sending HABP request packets every 20 seconds
Bypass VLAN: 2
Table 26 Output description
Field Description
HABP Mode HABP mode of the current device, server or client
Sending HABP request packets every 20 seconds
The HABP server sends HABP request packets at an
interval of 20 seconds.
Bypass VLAN ID of the VLAN in which HABP packets are transmitted

HP 5120 SI Series Specifications

General

Operating Temperature	0°C to 45°C
Uplink Ports	4 x SFP
MAC Address Table Size	16384 entries
Routing Protocol	RIP, RIPng
Management	CLI, Web-based GUI, SNMP
Form Factor	1U
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (noncondensing)