HP 5120 SI Series

318
Description
Use the display fips status command to display the current FIPS mode.
Related commands: fips mode enable.
Examples
# Display the current FIPS mode.
<Sysname> display fips status
FIPS mode is enabled
fips self-test
Syntax
fips self-test
Views
System view
Default level
3: Manage level
Parameters
None
Description
Use fips self-test to trigger a self-test on the password algorithms.
To examine whether the cryptography modules operate normally, you can use a command to trigger a
self-test on the cryptographic algorithms. The triggered self-test is the same as the power-up self-test.
If the self-test fails, the device automatically reboots.
Examples
# Trigger a self-test on the cryptographic algorithms.
<Sysname> fips self-test
Self-tests are running. Please wait...
Self-tests succeeded.