HP 5120 SI Series

156
View
Interface view
Default level
2: System level
Parameters
server-name: Name of a portal server, a case-sensitive string of 1 to 32 characters.
method: Specifies the authentication mode to be used.
direct: Direct authentication.
layer3: Cross-subnet authentication.
Description
Use the portal server method command to enable Layer 3 portal authentication on an interface, and
specify the portal server and the authentication mode to be used.
Use the undo portal command to disable the specified portal server or all portal servers on an interface.
By default, Layer 3 portal authentication is disabled on an interface.
When you use the command on an interface, note these guidelines:
• The specified portal server must exist.
• You can enable both an IPv4 portal server and an IPv6 portal server for Layer 3 portal
authentication on an interface, but you cannot enable two IPv4 or two IPv6 portal servers on the
interface.
• If you do not specify a portal server in the undo portal command, the command removes all Layer
3 portal authentication configurations on the interface.
Related commands: display portal server.
Examples
# Enable Layer 3 portal authentication on interface VLAN-interface 100, referencing portal server pts
and setting the authentication mode to direct.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname–Vlan-interface100] portal server pts method direct
portal server server-detect
Syntax
portal server server-name server-detect method { http | portal-heartbeat } * action { log | permit-all |
trap } * [ interval interval ] [ retry retries ]
undo portal server server-name server-detect
View
System view
Default level
2: System level