HP 5120 SI Series

94
Field Description
Critical recovery-action
Action that the port takes when an active (reachable)
authentication server is detected available for the 802.1X
users in the critical VLAN:
reinitialize—The port triggers authentication.
NOT configured—The port does not trigger authentication.
Max number of on-line users Maximum number of concurrent 802.1X users on the port
EAPOL Packet Number of sent (Tx) and received (Rx) EAPOL packets
Sent EAP Request/Identity Packets Number of sent EAP-Request/Identity packets
EAP Request/Challenge Packets Number of sent EAP-Request/Challenge packets
EAP Success Packets Number of sent EAP Success packets
Fail Packets Number of sent EAP-Failure packets
Received EAPOL Start Packets Number of received EAPOL-Start packets
EAPOL LogOff Packets Number of received EAPOL-LogOff packets
EAP Response/Identity Packets Number of received EAP-Response/Identity packets
EAP Response/Challenge Packets Number of received EAP-Response/Challenge packets
Error Packets Number of received error packets
Authenticated user User that has passed 802.1X authentication
Controlled User(s) amount Number of authenticated users on the port
dot1x
Syntax
In system view:
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
In Layer 2 Ethernet interface view:
dot1x
undo dot1x
View
System view, Layer 2 Ethernet interface view
Default level
2: System level
Parameters
interface interface-list: Specifies a port list, which can contain multiple ports. The interface-list argument
is in the format of interface-list = { interface-type interface-number [ to interface-type interface-number ] }
& <1-10>, where interface-type represents the port type, interface-number represents the port number,
and & <1-10> means that you can provide up to 10 ports or port ranges. The start port number must be
smaller than the end number and the two ports must be of the same type.