HP 5120 SI Series

331
------------------------------------------------
connection id: 5
perfect forward secrecy:
SA's SPI:
inbound: 12345 (0x3039) [ESP]
outbound: 12345 (0x3039) [ESP]
tunnel:
flow:
current Encrypt-card:
Table 54 Output description
Field Description
connection id Connection ID, used to uniquely identify an IPsec Tunnel
perfect forward secrecy
Perfect forward secrecy, indicating which DH group is to be used for fast
negotiation mode in IKE phase 2
SA's SPI SPIs of the inbound and outbound SAs
tunnel Local and remote addresses of the tunnel
flow
Data flow protected by the IPsec tunnel, including source IP address,
destination IP address, source port, destination port and protocol
as defined in acl 3001 The IPsec tunnel protects all data flows defined by ACL 3001
current Encrypt-card Encryption card interface used by the current tunnel
encapsulation-mode
Syntax
encapsulation-mode { transport | tunnel }
undo encapsulation-mode
View
IPsec proposal view
Default level
2: System level
Parameters
transport: Uses transport mode.
tunnel: Uses tunnel mode.
Description
Use the encapsulation-mode command to set the encapsulation mode that the security protocol uses to
encapsulate IP packets.
Use the undo encapsulation-mode command to restore the default.
By default, a security protocol encapsulates IP packets in tunnel mode.
Related commands: ipsec proposal.