367
interval-time
Syntax
interval-time interval-time
undo interval-time
View
IKE DPD view
Default level
2: System level
Parameters
interval-time: Sets DPD interval in seconds, in the range of 1 to 300 seconds. When the local end sends
an IPsec packet, it checks the time the last IPsec packet was received from the peer. If the time interval
exceeds the DPD interval, it sends a DPD hello to the peer.
Description
Use the interval-time command to set the DPD query triggering interval for a DPD detector.
Use the undo interval-time command to restore the default.
The default DPD interval is 10 seconds.
Examples
# Set the DPD interval to 1 second for dpd2.
<Sysname> system-view
[Sysname] ike dpd dpd2
[Sysname-ike-dpd-dpd2] interval-time 1
local-address
Syntax
local-address ip-address
undo local-address
View
IKE peer view
Default level
2: System level
Parameters
ip-address: IP address of the local security gateway to be used in IKE negotiation.
Description
Use the local-address command to configure the IP address of the local security gateway in IKE
negotiation.
Use the undo local-address command to remove the configuration.
To Next Page
Loading...
