95
Description
Use the dot1x command in system view to enable 802.1X globally.
Use the undo dot1x command in system view to disable 802.1X globally.
Use the dot1x interface command in system view or the dot1x command in Layer 2 Ethernet interface
view to enable 802.1X for specified ports.
Use the undo dot1x interface command in system view or the undo dot1x command in Layer 2 Ethernet
interface view to disable 802.1X for specified ports.
By default, 802.1X is neither enabled globally nor enabled for any port.
802.1X must be enabled both globally in system view and for the intended ports in system view or Layer
2 Ethernet interface view. Otherwise, it does not function.
You can configure 802.1X parameters either before or after enabling 802.1X.
Related commands: display dot1x.
Examples
# Enable 802.1X for ports GigabitEthernet 1/0/1, and GigabitEthernet 1/0/5 to GigabitEthernet
1/0/7.
<Sysname> system-view
[Sysname] dot1x interface gigabitethernet 1/0/1 gigabitethernet 1/0/5 to gigabitethernet
1/0/7
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/5
[Sysname-GigabitEthernet1/0/5] dot1x
[Sysname-GigabitEthernet1/0/5] quit
[Sysname] interface gigabitethernet 1/0/6
[Sysname-GigabitEthernet1/0/6] dot1x
[Sysname-GigabitEthernet1/0/6] quit
[Sysname] interface gigabitethernet 1/0/7
[Sysname-GigabitEthernet1/0/7] dot1x
# Enable 802.1X globally.
<Sysname> system-view
[Sysname] dot1x
dot1x authentication-method
Syntax
dot1x authentication-method { chap | eap | pap }
undo dot1x authentication-method
View
System view
To Next Page
Loading...
Need help?
General