HP 5120 SI Series

351
IKE configuration commands
IKE configuration commands are available only for the switches in FIPS mode. For more information
about FIPS mode, see Security Configuration Guide.
authentication-algorithm
Syntax
authentication-algorithm sha
undo authentication-algorithm
View
IKE proposal view
Default level
2: System level
Parameters
sha: Uses HMAC-SHA1.
Description
Use the authentication-algorithm command to specify an authentication algorithm for an IKE proposal.
Use the undo authentication-algorithm command to restore the default.
By default, an IKE proposal uses the SHA1 authentication algorithm.
Related commands: ike proposal and display ike proposal.
Examples
# Set SHA1 as the authentication algorithm for IKE proposal 10.
<Sysname> system-view
[Sysname] ike proposal 10
[Sysname-ike-proposal-10] authentication-algorithm sha
authentication-method
Syntax
authentication-method { pre-share | rsa-signature }
undo authentication-method
View
IKE proposal view
Default level
2: System level
Parameters
pre-share: Uses the pre-shared key method.