HP 5120 SI Series

105
dot1x multicast-trigger
Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use the dot1x multicast-trigger command to enable the 802.1X multicast trigger function. The device acts
as the initiator and multicasts EAP-Request/Identify packets periodically to the clients.
Use the undo dot1x multicast-trigger command to disable the function.
By default, the multicast trigger function is enabled.
Related commands: display dot1x.
Examples
# Enable the multicast trigger function on interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x multicast-trigger
dot1x port-control
Syntax
In system view:
dot1x port-control { authorized-force | auto | unauthorized-force } [ interface interface-list ]
undo dot1x port-control [ interface interface-list ]
In Layer 2 Ethernet interface view:
dot1x port-control { authorized-force | auto | unauthorized-force }
undo dot1x port-control
View
System view, Layer 2 Ethernet interface view
Default level
2: System level