HP 5120 SI Series User Manual

114
Default level
2: System level
Parameters
ead-timeout-value: Specifies the EAD rule timer in minutes. The value ranges from 1 to 1440.
Description
Use the dot1x timer ead-timeout command to set the EAD rule timer.
Use the undo dot1x timer ead-timeout command to restore the default.
By default, the timer is 30 minutes.
EAD fast deployment automatically creates an ACL rule, or EAD rule, to open access to the redirect URL
for each redirected user seeking to access the network. The EAD rule timer sets the lifetime of each ACL
rule. When the timer expires or the user passes authentication, the rule is removed. If users fail to
download EAD client or fail to pass authentication before the timer expires, they must reconnect to the
network to access the free IP.
To prevent ACL rule resources from being used up, you can shorten the timer when the amount of EAD
users is large.
Related commands: display dot1x.
Examples
# Set the EAD rule timer to 5 minutes.
<Sysname> system-view
[Sysname] dot1x timer ead-timeout 5
dot1x url
Syntax
dot1x url url-string
undo dot1x url
View
System view
Default level
2: System level
Parameters
url-string: Specifies the redirect URL, a case sensitive string of 1 to 64 characters in the format
http://string.
Description
Use the dot1x url command to configure a redirect URL. When a user uses a web browser to access
networks other than the free IP, the device redirects the user to the redirect URL.
Use the undo dot1x url command to remove the redirect URL.
By default, no redirect URL is defined.
The redirect URL must be on the free IP subnet.
If you configure the dot1x url command multiple times, the last configured URL takes effect.

HP 5120 SI Series Specifications

General

Brand	HP
Model	5120 SI Series
Category	Switch
Language	English