239
SSH2.0 configuration commands
The switch supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.
SSH2.0 server configuration commands
display ssh server
Syntax
display ssh server { session | status } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
session: Displays the session information of the SSH server.
status: Displays the status information of the SSH server.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Description
Use the display ssh server command on an SSH server to display SSH server status information or session
information.
Related commands: ssh server authentication-retries, ssh server rekey-interval, ssh server
authentication-timeout, ssh server enable, and ssh server compatible-ssh1x.
NOTE:
This command is also available on an SFTP server.
Examples
# Display the SSH server status information.
<Sysname> display ssh server status
SSH Server: Disable
SSH version : 1.99
To Next Page
Loading...
