EasyManua.ls Logo

HP 5120 SI Series

HP 5120 SI Series
395 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
296
Parameters
threshold-value: Threshold for source MAC address based ARP attack detection, in the range 10 to 100.
Description
Use the arp anti-attack source-mac threshold command to configure the threshold for source MAC
address based ARP attack detection. If the number of ARP packets sent from a MAC address within five
seconds exceeds this threshold, the switch considers this an attack.
Use the undo arp anti-attack source-mac threshold command to restore the default.
By default, the threshold for source MAC address based ARP attack detection is 50.
Examples
# Configure the threshold for source MAC address based ARP attack detection as 30.
<Sysname> system-view
[Sysname] arp anti-attack source-mac threshold 30
display arp anti-attack source-mac
Syntax
display arp anti-attack source-mac { slot slot-number | interface interface-type interface-number } [ |
{ begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Displays attacking MAC addresses detected on the interface.
slot slot-number: Displays attacking MAC addresses detected on the specified device. If the device is in
an IRF, the slot-number argument represents the member ID of the device; if the device is not in any IRF,
the slot-number argument represents the device ID.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display arp anti-attack source-mac command to display attacking MAC addresses detected by
source MAC address based ARP attack detection.
Examples
# Display the attacking MAC addresses detected by source MAC address based ARP attack detection.
<Sysname> display arp anti-attack source-mac slot 1
Source-MAC VLAN ID Interface Aging-time
23f3-1122-3344 4094 GE1/0/1 10

Table of Contents

Other manuals for HP 5120 SI Series

Related product manuals