HP 5120 SI Series

212
ssh-rsa
AAAAB3NzaC1yc2EAAAADAQABAAAAgQDAo0dVYR1S5f30eLKGNKuqb5HU3M0TTSaGlER2GmcRI2sgSegbo1x6u
t5NIc5+jJxuRCU4+gMc76iS8d+2d50FqIweEkHHkSG/ddgXt/iAZ6cY81bdu/CKxGiQlkUpbw4vSv+X5KeE7j
+o0MpOpzh3W768/+u1riz+1LcwVTs51Q== rsa-key
public-key peer
Syntax
public-key peer keyname
undo public-key peer keyname
View
System view
Default level
2: System level
Parameters
keyname: Specifies the public key name of a remote host, a case sensitive string of 1 to 64 characters.
Description
Use the public-key peer command to specify a name for a remote host's public key and enter public key
view.
Use the undo public-key peer command to remove a remote host's public key.
To manually configure a remote host's public key on the local host, obtain the public key (in hexadecimal)
from the remote host beforehand and perform the following configurations:
1. Execute the public-key peer command, and then the public-key-code begin command to enter
public key code view.
2. Type the public key of the remote host.
3. Execute the public-key-code end command to save the public key and return to public key view.
4. Execute the peer-public-key end command to return to system view.
Related commands: public-key-code begin, public-key-code end, peer-public-key end, and display
public-key peer.
Examples
# Specify the name for the remote host's public key as key1 and enter public key view.
<Sysname> system-view
[Sysname] public-key peer key1
[Sysname-pkey-public-key]
public-key peer import sshkey
Syntax
public-key peer keyname import sshkey filename
undo public-key peer keyname
View
System view