HP 5120 SI Series

317
FIPS configuration commands
fips mode enable
Syntax
fips mode enable
undo fips mode enable
View
System view
Default level
2: System level
Parameters
None
Description
Use the fips mode enable command to enable the FIPS mode.
Use the undo fips mode enable command to disable the FIPS mode.
By default, the FIPS mode is disabled.
After you enable the FIPS mode, reboot the switch to make your configuration effective. After the switch
starts up, the switch works in FIPS mode. The FIPS mode complies with the FIPS 140-2 standard.
Related commands: display fips status.
Examples
# Enable the FIPS mode.
<Sysname> system-view
[Sysname] fips mode enable
FIPS mode change requires a device reboot. Continue?[Y/N]:y
Change the configuration to meet FIPS mode requirements, save the configuration to the
next-startup configuration file, and then reboot to enter FIPS mode.
display fips status
Syntax
display fips status
View
Any view
Default level
1: Monitor level
Parameters
None